Quantum Tape Drive A-Series Bedienungsanleitung PDF herunterladen (Seite 23)

Chapter 2 Getting Started

Resetting System Defaults

Quantum A-Series Tape Drives User’s Guide 7

Figure 2 Certificate of Security

Resetting System Defaults

As there is no access to the A-Series tape drive other than the Ethernet

port, a mechanism has been implemented to reset the settings to their

default values. This is useful if an end user loses the IP address of the

A-Series tape drive. The settings can all be set up through the Web

manager (i.e. IP settings, root password, ...).

To have the settings set back to their default values:

1 Switch off your tape drive.

2 Disconnect the network cable from the drive.

3 Repeat the following procedure three times:

a Insert a write protected cartridge into the drive.

b Switch on the tape drive.

c After approximately one minute, the cartridge will be ejected.

d Switch off the drive.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 104 105

Keine Kommentare

Quantum Tape Drive A-Series Bedienungsanleitung Seite 23