Quantum TC2201E Betriebsanweisung PDF herunterladen (Seite 44)

Chapter 2 Getting Started

Interfaces and Connections

24 Quantum TC2201E User’s Guide

5 Specify the following settings for the port:

6 Proceed to the following instructions on connecting the power to the

TC2201E.

Connecting the

Power Cable

The power supply used with the TC2201E supports 100 - 240 VAC (Auto

Sensing), but the correct type of power cable needed for your installation

should still be verified. The power cable shipped with the TC2201E is a

120 VAC 3-conductor power cable for use in the United States and

Canada. This is the power cable that should be used with the TC2201E

unless your installation requires otherwise, in which case you should

obtain the appropriate power cable as needed.

To connect the power cable to the TC2201E:

1 Connect the female end of the power cable to the power connector on

the back panel of the TC2201E.

2 Plug the male end of the power cable into the power source.

3 Switch on power to the TC2201E using the Power Switch located on

the back panel of the TC2201E.

If accessing the serial port, once you set the baud rate in the terminal

emulator, wait until the TC2201E completes the Power-On Self Test

(POST) and then the Firmware Initialization process. This can take up

Baud Rate: 9600, 19200, 38400, 57600, or 115200

Data Bits: 8

Stop Bits: 1

Parity: None

Flow

Control:

None or XON/XOFF

Note: Before initially powering on the TC2201E, make sure all

the storage devices are powered on first and that they have

finished performing their self tests. This will help ensure

that device discovery works correctly.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 201 202

Keine Kommentare

Quantum TC2201E Betriebsanweisung Seite 44