Quantum DAT 40 Drive Betriebsanweisung PDF herunterladen (Seite 7)

Scorpion 40 configurations for Windows NT, Novell, and UNIX 4

Novell 5.x

There are two possible ways to configure the Scorpion 40 to work

with Novell 5.x, depending on which tape driver you use.

Configuration 1:

If you are still using the original Novell NWTAPE

driver or any version created before 11/3/99, you must change the

Operating-System Configuration Dip switches so that switches 5 and

8 are OFF, as shown in the table on the front of this sheet. This is

different from their default settings (all switches ON).

Operating System / tape

driver software

Switch

Novell 5.x

w/ native backup

applet using NWTAPE.CDM

driver dated

before

11/3/99

OFFONONOFF

Configuration 2:

If you use the

latest

Novell NWTAPE driver

(available on the Novell web site), the Operating-System

Configuration Dip switches can be left in their default positions (all

switches ON). Before installing the new NWTAPE driver, first rename

the old NWTAPE driver (usually found in the system directory). Then

copy the new version of NWTAPE into the same directory. Do not

delete the old driver, because it might come in handy in resolving

future problems.

Operating System / tape

driver software

Switch

Novell 5.x

w/ native backup

applet using NWTAPE.CDM

driver dated

after

11/3/99

ON ON ON ON

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Keine Kommentare

Quantum DAT 40 Drive Betriebsanweisung Seite 7