Quantum DX Bedienungsanleitung PDF herunterladen (Seite 6)

6 Basic Operation Instructions DX Scanner

SELECT MODE

1. Press the On/Off Button on the DX compatible Master Remote used on

your power chair. The Module Status LED on the Scanner will light up,

indicating that it is in Standby Mode and ready for use.

2. Press the Select Switch once to activate the Scanner. All three Mode

LEDs will light up.

3. After power up, the Scanner will begin running through the three modes

Drive, Seat, and Environmental. Each Mode LED will light up in

sequence. To choose a mode, you must wait for its LED to light up, then

press the Select Switch.

Figure 2. Directional LEDs

DRIVE MODE

1. Press the Select Switch when the Drive Mode LED is lit. Once selected,

the Scanner will cycle through the available drive directions.

NOTE: If the Select Switch is not pressed within three scanning cycles

of the Drive Mode, the Scanner will exit that mode.

NOTE: The Scanner will run through each Mode LED five (5) times

before returning to Standby Mode.

2. To move in any direction, wait

until the desired Directional LED

is lit, then press and hold down

the Select Switch to move your

power chair in that direction. The

Scanner will automatically return

to the Forward Direction LED

after any power chair movement.

See figure 2.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

Quantum DX Bedienungsanleitung Seite 6