Quantum PX720 Installationshandbuch PDF herunterladen (Seite 23)

Quantum PX720 Unpacking and Installation Instructions

Document 6444602-04 A01

March 2005

Installing the Quantum PX720 Library 23

5 Repeat step 4 until the front is level.

6 Repeat step 3

and step 4 for the left edge, back edge, and right edge of the

library.

7 Recheck the level on all top edges.

8 If necessary, repeat step 3

and step 4 until all four top edges of the library

are level.

The unpacking is complete.

Installing the Quantum PX720 Library 0

Installing the Quantum PX720 library consists of the following steps:

• Cabling the Quantum PX720

• Connecting the Cluster Controller Ethernet Cables

• Cabling a SCSI PX720 Library

• Cabling a Fibre Channel PX720 Library

• Loading the Tape Cartridges

• Initial Configuration

Cabling the Quantum

PX720

After the Quantum PX720 is in its final location, the tape drives and robotics

controller must be connected to the backup host system(s). The cluster

controllers must also be connected with Ethernet cables. The PX720 supports

both SCSI and Fibre Channel host interfaces.

Refer to the appropriate section for your PX720 installation:

• Connecting the Cluster Controller Ethernet Cables

• Cabling a SCSI PX720 Library

• Cabling a Fibre Channel PX720 Library

Connecting the Cluster Controller Ethernet Cables 0

To connect the Cluster Controller Ethernet cables:

1 Open the back door of the Quantum PX720 to gain access to the tape

drive cluster controllers (see figure 25

on page 26).

2 Refer to table 1

and figure 24 for the tape drive cluster Ethernet

connections.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 37 38

Keine Kommentare

Quantum PX720 Installationshandbuch Seite 23