Quantum SuperLoader 3 Betriebsanweisung PDF herunterladen (Seite 14)

14 Connecting SCSI, SAS, or Fibre Channel and Power Cables

SuperLoader 3 Quick Start Guide

LTO-5 Tape Drive SAS Connectors

SuperLoader 3 systems with a LTO-5 tape drive contain a SAS 2 connector (see

Figure 11

Figure 11 SAS 2 Connector

Connector shown outside of

system for clarity.

Notch in SAS 2

connectors

The SAS 2 connector contains a notch that allows SAS 2 cables that are longer than 4

meters to be connected to the device.

Note: Quantum recommends using SAS cables that are no longer than 4 meters when

connecting to a host.

Connecting the Cables To connect the SCSI, SAS, Fibre Channel and power cables:

1 Shut down

and turn off the selected server. Turn off all attached accessory devices,

such as printers and other SCSI devices.

2 Attach on

e end of the SCSI cable (included in the accessory kit) to one of the

connectors on the back panel of the autoloader (see figure

14).

3 Attach the othe

r end of the SCSI cable to the connector on the SCSI host adapter or

to the connector on the previous device on the SCSI bus.

Note: If your autoloader is equipped with a Fibre Channel or SAS tape drive, a Fibre

Channel (see

figure 12) or SAS (see figure 13) cable replaces the SCSI cable and

terminator.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

Quantum SuperLoader 3 Betriebsanweisung Seite 14