Quantum 1200 Series DAT Autochanger Betriebsanweisung PDF herunterladen (Seite 10)

Quantum Bezel Replacement Guide

Document 81-81252-05 A01

October 2006

2 Place the decal adhesive-side up on the work surface.

3 Remove the two mounting screws from the bezel using a TORX-bit

screwdriver (see figure 1

). Carefully set the screws aside; you will use

them to reinstall the bezel later.

4 Place the tape drive on its rear so the front of the tape drive faces up.

5 Lift the bottom edge of the bezel away from the tape drive at a 45° angle.

Holding the bezel at a 45° angle, gently slide the three top bezel tabs out

of their slots and lift off the bezel (see figure 1

6 Re-affix the decal to the bezel.

Install the New Bezel 0 1 Place the tape drive on its rear so the front of the tape drive faces up.

2 Hold the bezel at a 45° angle to the top of the tape drive (see figure 2

Figure 2 SDLT 600/DLT-S4

Install

3 Insert the three top bezel tabs into the slots on the top cover of the tape

drive.

4 Lower the bezel into place.

5 Insert the two bezel mounting screws and tighten until snug using the

TORX-bit screwdriver.

6 Remove the adhesive backing from the new decal and affix the decal to

the bezel.

Caution: The lower right corner of the decal covers an opening into

the infrared port of the tape drive (SDLT 600 only). Avoid

this area when removing the decal. If the instrument slips

into the hole, you can damage delicate tape drive

components.

Caution: Do not over-tighten. The plastic bezel should not bend as

you tighten the screws.

45°

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 53 54

Keine Kommentare

Quantum 1200 Series DAT Autochanger Betriebsanweisung Seite 10