Quantum Scalar i6000 Hinweis PDF herunterladen (Seite 7)

Quantum Scalar i6000 Release Notes

6-66883-41 Rev A

June 2015

Known Issues 7

54202 If you disconnect the cable from a control

path drive that is connect to a host HBA,

the library will lose connectivity to the

robot.

1 Update path to robot.

2 run library audit

checklabel = barcode.

3 Media will now return to its home

slot.

4 Users are now able to run

simultaneous backups to both

drives without repairing FC

connection on Host HBA.

54220 If the control path drive fails over during

an import, any media in the picker will not

be discovered.

1 Run checkin libvolume search=yes

to pickup missing media

2 Then rerun the checkin libvolume

search=bulk to import remaining

media in I/E.

54580 A Series 3 control module may show the

presence of two CMBs even though there

is only one.

There is no negative effect to library

functionality. The second CMB listed

is actually the MCB.

54630 3948014 If the email addresses in the Contact tab

of the Notifications dialog and the Email

Notifications dialog are the same, an

email will ‘bounce’ (ie, undeliverable) and

fail to be delivered.

Check:

Setup > Notifications > System

Setup (Email Address field), and

Setup > Email Configuration

(Sender Address field)

54852 During a change to the internal IP of the

library the GUI can hang if you wait too

long to respond to dialog prompts.

Respond to the dialog prompts in a

timely manner. If you do wait too

long, reboot the library.

55202 When upgrading from i11.x to i12.x, all

ticket suppression filters will not be

restored. Restoring a configuration back to

i11.3 will also not restore the filters.

Before the upgrade, note which

filters you have set and then reset

them after the upgrade is complete.

55216 In libraries larger than 8 frames,

a geo-addressing issue may cause

diagnostic tickets related to CMBs and

HDCs to be generated in error.

Reboot the library.

55492 When upgrading from i11.3 to i12.2.1, the

partition is not mapped or listed in the

Access Group Configuration.

1 Go to Setup > SNW Wizard.

2 Click Next.

3 Select Host Access radio button.

4 Click Next.

5 Select Host Access Configuration.

6 Click Next.

7 Select Group.

8 Expand Tree.

Change

Request

Number

Service

Request

Number

Description Workaround

1 2 3 4 5 6 7 8 9 10

Kommentare zu diesen Handbüchern

Keine Kommentare