Quantum FastStor 2 Bedienungsanleitung PDF herunterladen (Seite 3)

FastStor 2 Installing or Removing a Barcode Reader 3

Installing the L-Brackets to the Autoloader

The rackmount kit contains two front L-brackets that must be installed to the autoloader before you can

rackmount it.

1 Turn off the autoloader and then remove the SCSI cable(s) and power cable from the rear of the

autoloader.

2 Using a small flat blade screwdriver, remove the front two screws that secure the right side and left side

of the autoloader cover.

3 Save the screws for step 5.

4 Position the L-brackets to the side of the autoloader as shown in the following figure by matching the

holes on the brackets to the holes on each side of the autoloader cover. Using the following figure, verify

that the hole on the front flange is placed at the top.

5 Using a small flat blade screwdriver, attach the L-brackets the autoloader with the screws from step 2.

Installing the Autoloader to the Rack

Once you attach the L-brackets to your autoloader, you can slide the autoloader into the rails.

1 If you have a non-threaded rack, slide two clip nuts onto the rack where you are installing the

autoloader. If you have a pre-threaded rack, skip this step.

2 Position the autoloader in the rack by sliding it into the rail assembly and matching the holes in the rack

with the holes on the L-brackets.

1 2 3 4 5 6

Keine Kommentare

Quantum FastStor 2 Bedienungsanleitung Seite 3