Quantum FastStor 2 Bedienungsanleitung PDF herunterladen (Seite 5)

FastStor 2 Installing or Removing a Barcode Reader 5

Converting from Rackmount to Desktop

When converting a rackmounted autoloader to a desktop unit, you must first remove the unit from the

rackmount assembly and then remove the L-brackets from the autoloader.

1 Turn off the autoloader and remove the SCSI cable(s) and power cord from the rear of the autoloader.

2 Using a # 2 Phillips head screwdriver, remove the screws that secure the L-brackets to the rack.

Store the screws in a secure location.

3 Slide the autoloader out of the rack and set it on a cleared, flat work surface.

4 Using a # 2 Phillips head screwdriver, remove the rail assemblies by removing the screws and clip nuts

(if applicable) that secure them to the rack.

Store the screws and clip nuts (if applicable) in a secure location.

5 Using a small flat blade screwdriver, remove the screws that secure the L-brackets to the front of the

autoloader (two on each side).

Store the L-brackets in a secure location.

1 2 3 4 5 6

Keine Kommentare

Quantum FastStor 2 Bedienungsanleitung Seite 5