Quantum DAT72 Betriebsanweisung PDF herunterladen (Seite 24)

Chapter 2 Installing Internal Tape Drives

Collecting the Necessary Tools

DDS-4/DAT 72 User’s Guide 12

Collecting the Necessary Tools 2

Before proceeding with the installation, gather the tools you will need to

install the internal tape drive into the computer mounting bay. The

following list identifies some of the tools you will need. You may need

additional items, depending on your installation requirements.

• PHILLIPS screwdriver

• Flatblade screwdriver, if your computer uses flathead screws

• TORX screwdriver, if your computer uses TORX screws

• Computer documentation, which you can refer to during the

installation

Reviewing Drive Default Settings 2

Your internal tape drive comes with various default settings. These

settings are configured using jumpers and switches.

• The jumpers are located on the back of the drive, between the SCSI

interface and power connectors

• The switches are located on the underside of the drive. If you change

a switch setting, you must turn the power to the drive off and then on

to have the new setting take effect.

You may need to change these settings to suit your requirements. Review

the default settings in table 2

to determine whether they suit your

requirements or need to be changed.

• If you do not need to change these default settings, proceed to

Accessing the Inside of Your Computer

on page 24.

Note: These jumper pin and switch settings are for the SCSI drive

only.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 80 81

Keine Kommentare

Quantum DAT72 Betriebsanweisung Seite 24