Quantum LTO-6 Betriebsanweisung PDF herunterladen (Seite 12)

No mounting hardware used

1. Use 4mm M3 screws. Check that the holes in the chassis are aligned with the holes in the sides

of the drive and use a regular Phillips screwdriver to secure the M3 screws, as shown in the

following ﬁgure.

If you cannot tighten the screws, use washers.

1. M3 screws, supplied with tape drive

Figure 7 Securing drive, no mounting hardware used

2. Ensure blanking plates are in place over empty bays and replace the cover on the server.

Reboot the server

Reboot the server to power up the tape drive and server.

Watch the boot screen carefully after installation. If there are any error or unexpected messages go

back and check the SAS cabling carefully.

• Have you installed the SAS cable correctly?

• Have you reconnected all devices securely?

If this does not resolve the problem, refer to Troubleshooting (page 27) for further guidelines.

12 Installing an internal LTO Ultrium tape drive

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 37 38

Keine Kommentare

Quantum LTO-6 Betriebsanweisung Seite 12