Quantum SuperLoader 3 Bedienungsanleitung

www.quantum.comSuperloader 3Quantum SuperLoader®3: Lodged Tape Removal InstructionsThis document provides instructions for removing a lodged tape cart

10 Tape Removal - Removing Top CoverSuperLoader 3 Stuck Tape Removal InstructionsTape Removal - Removing Top CoverIn an effort to retain your tape(s),

Tape Removal - Removing Top Cover 11Quantum SuperLoader 3Figure 11 Removing Top Cover ScrewsT8 Torx screws (2)T8 Torx screws (4)T10 Torx screws (4)Fi

12 Tape Removal - Removing Top CoverSuperLoader 3 Stuck Tape Removal InstructionsFigure 13 Removing the Back Cover ScrewsT8 Torx screws (2)6 Grasp th

Tape Removal - Removing Top Cover 13Quantum SuperLoader 3Figure 15 Disengaging the Top Cover

14 Tape Removal - Removing Top CoverSuperLoader 3 Stuck Tape Removal Instructions7 Using your index finger on each side of the bezel, depress the beze

Tape Removal - Removing Top Cover 15Quantum SuperLoader 38 Move the two swing arms located on the gear shaft to the “up” position (see Figure 17).Fig

16 Tape Removal - Removing Top CoverSuperLoader 3 Stuck Tape Removal InstructionsRemoving Lodged Tape from TurntableTo remove the lodged tape from the

Tape Removal - Removing Top Cover 17Quantum SuperLoader 32 Once the turntable top is removed, the lodged tape inside the turntable is exposed and can

Preserving the World’s Most Important Data. Yours.™©2012 Quantum Corporation. All rights reserved. Quantum, the Quantum logo, and all other logos are

2 Dislodging a Stuck TapeSuperLoader 3 Stuck Tape Removal InstructionsDislodging a Stuck TapeUse the following steps when dislodging a stuck tape in a

Dislodging a Stuck Tape 3Quantum SuperLoader 3Note: This system error prevents you from entering a Move command through the OCP. 2 Power cycle the uni

4 Tape Removal Without Removing the Top CoverSuperLoader 3 Stuck Tape Removal InstructionsTape Removal Without Removing the Top CoverThis procedure in

Tape Removal Without Removing the Top Cover 5Quantum SuperLoader 32 At the bottom of the slot, push the latch out of the way to manually eject the mag

6 Tape Removal Without Removing the Top CoverSuperLoader 3 Stuck Tape Removal InstructionsFigure 6 Barcode Reader Ribbon CableRibbon cable6 Using a f

Tape Stuck in Drive 7Quantum SuperLoader 39 If the tape is successfully removed, reinstall the magazine or magazines into the unit and power up the un

8 Tape Stuck in DriveSuperLoader 3 Stuck Tape Removal Instructions3 Disconnect all data cables from Superloader.4 Power cycle the unit and wait 10 min

Tape Stuck in Drive during Backups or Restores in Backup Exec 9Quantum SuperLoader 3Tape Stuck in Drive during Backups or Restores in Backup ExecWhen