Quantum DAT 24 Drive Betriebsanweisung PDF herunterladen (Seite 173)

Commands: Verify (13h) Page 161

The byte compare starts on a block boundary starting at the current tape block

position.

Completion Status

The Completion Status for the VERIFY command is shown in the following table.

Code Message Description

00h Good

Status

• The drive is ready to perform any appropriate command.

• The drive remains in any previously set mode.

• The tape is positioned on the EOT side of the last block verified.

02h Check

Condition

Extended Sense Byte 02h:

Code Message Description

02h Not Ready No cartridge is inserted in the drive.

03h Media Error Unrecoverable data error was encountered.

04h Hardware Error Drive hardware failure detected.

05h Illegal Request The CDB contains an invalid bit.

06h Unit

• Cartridge was changed prior to accepting

Attention this command

• The drive was reset prior to this command.

08h Blank Check

• End of recorded data was encountered.

0Eh Miscompare VERIFY data miscompare.

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 179 180 181

Keine Kommentare

Quantum DAT 24 Drive Betriebsanweisung Seite 173