DLT8000 Tape Drive product manual (order number 81-60118)●
Set the DLT SCSI device address to an unassigned ID.
Reboot the system. During the boot sequence, the system adds the DLTtape tape peripheral to its customized
configuration table as a defined tape drive. The following steps will be used to verify that the system has added
the DLTtape tape peripheral.
2.
At the command line, enter smit.3.
Select
Devices.4.
Select Tape Drives.5.
Select
List All Supported Tape Drives.
The system displays a table similar to the following:
type subclass description
1200mb-c SCSI 1200 MB 1/4-inch Tape Drive
150mb SCSI 150 MB 1/4-inch Tape Drive
525mb SCSI 525 MB 1/4-inch Tape Drive
8mm SCSI 2.3 GB 8mm Tape Drive
8mm5tgb SCSI 5.0 GB 8mm Tape Drive
9trk SCSI 1/2-inch 9-trk Tape Drive
ost SCSI Other SCSI Tape Drive
6.
Select List All Defined Tape Drives
The system will display the tape drives connected to SCSI I/O controller(s) as in the example shown below.
(Note below that the system may return a status of either Defined or Available.):
name status location description
rmt1 Defined 00-00-0S-50 Other SCSI Tape Drive.
Where:
name
- the logical name of the DLTtape tape peripheral(rmt1)
status
- whether the peripheral is defined (known, but not ready for use) or available (ready for use)
location
- the SCSI ID of the DLTtape tape peripheral (5 in the sample) and the address of the SCSI
I/O controller (the 0 that follows the 5 in the sample above)
description
- a short description of the tape drive type. In the sample above, the DLTtape tape peripheral
is described as other SCSI tape drive
7.
If the status is reported as Available for the device at the SCSI ID address of interest, then the installation is
complete, otherwise, go to Step 9.
The DLTtape tape peripheral must have available status in order for it to be ready for use. Should the status
indicate Defined in Step 7, then the following steps will enable the status to be changed to Available.
8.
Under the Devices, Tape Drive selection in smit, select Configure a defined tape drive. The system displays a list
of defined tape drives.
9.
Select the DLTtape device by its logical address and location then select Ok. The system responds by reporting
the status of the command.
10.
To verify that the system has changed the device status from defined to available, select List All Supported tape
Drives. The system display should be similar to the following:
rmt1 Available
11.
http://corp-mkg/ebusiness/projects/1068/DLTAppNotes/qt00001.htm (2 of 4) [2/25/2000 1:05:31 PM]
(69 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern