Quantum LTO-4 (Model B) Technical Information PDF herunterladen (Seite 5)

Installing the Internal LTO-4 (Model B) Half-Height Tape Drive 5

Product Line

Figure 2 Internal Parallel SCSI

ID Configuration Jumper Pins

(Examples)

SCSI ID 2 SCSI ID 3 SCSI ID 5 SCSI ID 9 SCSI ID 13

TP NC 8 4 2 1TP NC 8 4 2 1TP NC 8 4 2 1TP NC 8 4 2 1TP NC 8 4 2 1

Note: Parallel SCSI controllers and host adapters generally use ID 7. In some systems,

the boot drive uses ID 0 or ID 1. Avoid configuring the LTO-4 (Model B) Half-

Height Tape Drive to these SCSI IDs.

Configuring the Internal Parallel SCSI Terminator Power

By default, terminator power is enabled on the internal parallel SCSI LTO-4 (Model B)

Half-Height Tape Drive. If you use this default setting, then the last device at the end of

the parallel SCSI bus must have either:

• A parallel SCSI bus terminator

• Terminator power enabled

See figure 3 for examples of internal parallel SCSI bus termination.

To disable terminator power, remove the termination power (TP) jumper (see figure 2

1 2 3 4 5 6 7 8 9 10 ... 17 18

Keine Kommentare

Quantum LTO-4 (Model B) Technical Information Seite 5