SDLT 220 and SDLT 320 Design & Integration Guide CHAPTER 6: SCSI and Controller Interface Specification
81-81148-01 March 2004 6-3
NOTE: The computer system and the tape drive SCSI IDs are only
checked at power-on. To change the SCSI ID after
installation, power down both the system and the tape
drive, change the drive’s SCSI ID, power up the tape drive,
and then power up the system.
Table 6-1. SCSI ID Address Selections (Graphical Format)
SCSI ID0123
Jumper Block
SCSI ID 4 5 (default) 6 7
Jumper Block
u
SCSI ID891011
Jumper Block
SCSI ID 12 13 14 15
Jumper Block
1
Kommentare zu diesen Handbüchern