Quantum Qflash X4d Betriebsanleitung PDF herunterladen (Seite 11)

Your Qflash is factory preset with several Programs (which you can always

change). To view them, press Mode I, then Up J or Down L until you

see the Program mode displayed, like the one above. After the “P” stops

blinking, press the Up J or Down L buttons jump to the next higher, or

lower program number. (Programs numbers which have not been “set” will

be skipped).

How to set up or change a Program

While in the Program mode, press the Set G button. The program

number will blink, and the Up/Down JLbuttons will select the program

number you wish to set or change. All program numbers will be displayed

this way, even those that were “skipped” above.

Press Set G again (or press it twice if the Program number stopped blink-

ing). The mode (Manual, Auto, TTL, etc.) will be blinking. Press Up J or

Down L to select your flash mode for this program.

Once your flash mode is selected keep pressing Set G to choose param-

eters to program. To change any settings use the same procedures as the

usual for Manual, Auto, TTL, or Wireless/Wired modes (see Sections 5.4,

5.5, 5.6, and 8.0 )

There are times when you will want to “clear” a Program from memory.

Clearing unwanted programs allows for quicker switching between stored

programs during actual shoots. For example, if you need just 3 Programs for

a job, and you clear out the other 5 Program numbers, you will cycle through

just the 3 Programs you want for a shoot, using the Up/Down JLbuttons.

To clear out a Program

Start in the Program number you wish to clear. Press Set G until the

‘mode’ blinks in the display. Press Up J or Down L until the word CLEAR

appears. After several seconds the display will stop blinking and the pro-

gram will be cleared from memory.

Note: You can never clear out Program 1.

5.9 Option

■ button

The Option ■ button lets you set various features and preferences for

your Qflash.

There are two Option menus. Press the Option ■ button once to enter

into Option menu #1. Press Option ■ twice to enter into Option menu #2.

Press Option ■ again to return to original display.

You may select any option to change by pressing the Set G button until

the option blinks. Then use the Up/Down JLbuttons to make the

change.

Option menu #1

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 43 44

Keine Kommentare

Quantum Qflash X4d Betriebsanleitung Seite 11