Quantum Qflash X4d Betriebsanleitung PDF herunterladen (Seite 21)

Press the Mode I button on the Qflash that you want to be the Control

Qflash (usually the one at the camera). The display for this Qflash will

change to ‘Wired Control’, and display the data for Remote 1 (R1) and

Remote 2 (R2).

The displays of the two Remote Qflashes will automatically change to R1

and R2. To change which Qflash is Remote 1 and 2 see Section 7.5.

To designate another Qflash to be the Control, press Set G on the Control

flash. “Control” will blink. Use the Up/Down JLbuttons to return to the

display prompt: “Press Mode button to select Control flash.” All flashes will

display the prompt. Select the new Control flash by pressing the Mode I

button on the new Control Qflash.

When only one Remote Qflash is attached, the Control Qflash displays a

series of dashes for R2, like this:

7.1.2 Changing the setting on the Control flash

Always select the settings you desire for the Control Qflash first. Those

settings determine the choices you have for the Remotes.

Press Set G until “C” is blinking. (If “R1” or “R2” is blinking instead, press

the Up/Down JLbuttons until “C” blinks).

Press Set G again. The mode of the Control flash will blink. Use the

Up/Down buttons to select the mode. The choices are Man, Auto, TTL,

Auto Fill, QTTL (if a D series adapter connects to the camera), and OFF.

When the Control Qflash is set to OFF it will not fire, however, Remotes

1 and 2 will still fire (if they are not also set to OFF).

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 43 44

Keine Kommentare

Quantum Qflash X4d Betriebsanleitung Seite 21