Quantum Scalar i500 Bedienungsanleitung PDF herunterladen (Seite 6)

6 Scalar i500 Getting Started Guide

Step 1: Unpack the Library

1 Unpack the library.

Following the unpacking instructions that came with the library, remove the library exterior packaging

but leave the library in the bottom packaging tray.

2 Check the contents of the package against the packing slip.

3 Remove the interior packaging.

4 Remove the tape drives from the library.

For information about removing tape drives, see “Adding, Removing, and Replacing” in the Scalar i500

User’s Guide.

5 Remove the power supplies from the library.

For information about removing power supplies, see “Adding, Removing, and Replacing” in the Scalar

i500 User’s Guide.

6 Choose an optimal location for the library.

To avoid damage, the library must be positioned in a stable location. See the System, Safety, and

Regulatory Information Guide for more information on finding an optimal location for your library.

• Make sure a power source (only of the type marked on the product label) is available. For power

requirements, see the ”Specifications” chapter in the Scalar i500 User’s Guide.

• Route any cables to avoid walking on them or pinching them with items placed on or against them.

Pay particular attention to the cord at the wall receptacle and the point where the cord exits from

the library. For recommended cabling procedures, see the Scalar i500 User’s Guide.

• Make sure that objects will not fall and liquids will not spill into the library’s chassis through

openings.

CAUTION

Save all packing materials in case you need to move or ship the

library in the future.

CAUTION

Be sure to remove the following items:

• The strap holding the robot in place. Release the velcro and unhook

each end of the strap.

• All cardboard and foam surrounding the robot.

WARNING

WITHOUT TAPE DRIVES, TAPE CARTRIDGES, OR POWER

SUPPLIES, A 5U CONTROL MODULE WEIGHS APPROXIMATELY 58

LBS. A 9U EXPANSION MODULE, WITHOUT TAPE DRIVES, TAPE

CARTRIDGES, OR POWER SUPPLIES, EXCEEDS 65 LBS. TO AVOID

SERIOUS INJURY, TWO PEOPLE ARE REQUIRED TO SAFELY LIFT

THE MODULES INTO POSITION.

WARNING

THE POWER OUTLET MUST BE AVAILABLE NEAR THE LIBRARY

AND MUST BE EASILY ACCESSIBLE.

1 2 3 4 5 6 7 8 9 10 11 ... 147 148

Keine Kommentare

Quantum Scalar i500 Bedienungsanleitung Seite 6