Quantum DPA Betriebsanweisung PDF herunterladen (Seite 49)

Initial Setup Setting the Initial Configuration

Configuring Email Settings

The Email Settings page lets you configure RemoteAdmin to send email notifications when Attentions

occur. When the CP 3100 sends an email about an Attention, the message identifies the CP 3100

by the host name you configured above and includes a description of the Attention condition.

1. Click CONFIGURATION, then click EMAIL. The Email Settings page appears (see

Figure 25 on page 51).

Table 5. Network Settings Page

Value Description

Host Name The host name that uniquely identifies the CP 3100. This value is optional and

defaults to the CP 3100's MAC address. However, it can be any descriptive text

you want.

IP Address The IP address that uniquely identifies the CP 3100 (up to four octets from 0 to

255, separated by periods). You enter this IP address in your browser to launch

RemoteAdmin. Default is: 192.168.0.250. The RemoteAdmin user must be on the

same subnet as the CP 3100. Be sure no other device on the subnet has this IP

address.

Network Mask The CP 3100 network mask, (up to four octets from 0 to 255, separated by peri-

ods). This value must match the network mask used by the subnet. Default is:

255.255.255.0

Default Gateway The IP address of the default gateway (up to four octets from 0 to 255, separated

by periods). This value is required if RemoteAdmin is to send email notifications.

Default is: 192.168.0.1

NOTE: Typically, your system administrator will provide you with these settings. If not, check

with your system administrator before selecting these values.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 100 101

Keine Kommentare

Quantum DPA Betriebsanweisung Seite 49