Quantum FastStor 2 Betriebsanweisung PDF herunterladen (Seite 24)

24 6-00515-03 Rev A

4. Attach the terminator to the remaining SCSI connector on the rear panel of the autoloader (if

the autoloader is the last or only device on the SCSI bus). Otherwise, attach the cable to the

next device on the SCSI bus. Make sure that the last device on the SCSI bus is properly

terminated.

5. Attach the female connector of the power cable to the power connector on the rear panel of the

autoloader.

6. Plug in the power cable to the nearest properly grounded power outlet, and then plug in the host

server system or workstation and all attached devices.

7. Turn on the autoloader by setting the power switch on the front panel to the ON position. You

will need to use the tip of a pen or similar item to move the switch to the desired position.

Check the LCD display to make sure the autoloader is receiving power. If it is not, check the

power connections and your power source. During the Power-On Self Test (POST), all four

LEDs are illuminated briefly, followed by just the Ready/Activity LED flashing. When the

initialization sequence is complete, the LCD screen displays the Home screen.

8. Turn on any other devices you turned off earlier, and then turn on the server.

NOTE:

If the SCSI cable does not fit the connector on your SCSI host system

adapter, you either have an incompatible SCSI host system adapter or you

need to purchase a cable adapter, or a different cable. Contact your service

representative or your SCSI host system adapter manufacturer for

information.

CAUTION:

To disconnect all power from the autoloader, remove the power

cord from the outlet. The power switch only puts the power on

stand-by.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 67 68

Keine Kommentare

Quantum FastStor 2 Betriebsanweisung Seite 24