Quantum Scalar 24 Spezifikationen PDF herunterladen (Seite 40)

32 Installing Optional Hardware

Installing the Scalar 24 in a Rack

Your Scalar 24 can easily be converted to a rackmount configuration. Follow the steps below to install your

Scalar 24 into a rack.

Special care should be taken when installing a Scalar 24 into a rack. Heed the following guidelines:

• For continued safe operation, the recommended maximum internal ambient temperature of the rack

should not exceed 100

°F (38°C).

• While installing a rack mounted unit, do not block or otherwise restrict airflow to the front or rear

vents.

• To maintain rack stability, consider the mechanical loading of the rack to ensure a low center of

gravity.

• Before installing a unit into a rack, consider the overall loading of the branch circuit supplying power

to the rack.

• Since this unit is intended to be attached to an earth ground, ensure that a reliable path to earth

ground is maintained within the rack.

Tools required: #3 Philips screwdriver and #1 Philips screwdriver

1 The Scalar 24 requires a 4U (7-inch) space in a standard 19-inch rack. Ensure that this amount of space

is available in the rack. Measure and mark the holes to simplify the subsequent steps.

2 Remove the rackmount assembly from packaging.

3 Power down your Scalar 24 and disconnect the AC line cord from the AC source outlet.

4 Disconnect the SCSI cable from the rear panel of your Scalar 24.

5 Using a #1 Philips screwdriver, take off the cosmetic cover of the Scalar 24 by removing the six screws

(3 per side) on the sides of the cover. Slightly bend the sides and lift the bottom edge of the cover away

from the unit. Lift the cover up to remove it.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 153 154

Keine Kommentare

Quantum Scalar 24 Spezifikationen Seite 40