Quantum DLT 7 Handbuch PDF herunterladen (Seite 104)

Chapter 10 Installing an Internal Fibre Channel Tape Drive

Connecting the Cables

DLT-S4 Product Manual 86

Connecting the Cables 10

Connect the Fibre Channel and power cables as follows:

1 Ensure that both the tape drive and computer are turned off.

2 Insert the fiber optic cable into the Fibre Channel port on the rear of

the tape drive (see figure 33

The connector is fully seated when it snaps into the port.

3 Insert the other end of the fiber optic cable into the Fibre Channel

port on the host computer.

4 Locate an available DC power cable in the host computer and attach

it to the power connector on the rear panel of the tape drive (see

figure 33

). The connector is keyed, preventing improper connection.

(See Power Connector Pin Assignments

on page 46 for power pin

number assignments and signal names.)

5 Check all cable connections to ensure that they are attached correctly,

seated firmly, and secured.

Note: If you are connecting several devices to the system,

connect only the tape drive to the host computer at this

time. Finish the installation procedure and confirm that

the host computer and tape drive are communicating

correctly before adding additional devices (see Adding

Additional Devices on page 88).

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 176 177

Keine Kommentare

Quantum DLT 7 Handbuch Seite 104