Quantum DLT 7 Handbuch PDF herunterladen (Seite 115)

Chapter 11 Installing an Internal SAS Tape Drive

Adding Additional Devices

DLT-S4 Product Manual 97

Adding Additional Devices 11

Once you have successfully confirmed the installation of your tape drive,

you may add additional devices.

For each additional device:

1 Ensure that both the tape drive and host computer are turned off.

2 Insert the SAS cable into the SAS port on the device (for tape drives,

see figure 34

3 Insert the other end of the SAS cable into the SAS port on the host

computer.

4 Check all cable connections and ensure that they are attached

correctly and seated firmly before turning the system on.

5 Confirm the installation (see Confirming the Installation on page 96).

Using the Loader/Library Interface Connector 11

This connector is only used for tape drives installed in loaders/libraries.

If your system requires it to be used, it should have been pre-assembled

at the factory. For more information about the loader/library connector,

see Loader/Library Interface Connector

on page 46.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 176 177

Keine Kommentare

Quantum DLT 7 Handbuch Seite 115