Quantum P2000 Betriebsanweisung PDF herunterladen (Seite 42)

Chapter 2 Basic Library Operations

Preparing the Library for Operation

22 ATL P2000 Series Automated Tape Library User’s Guide

Preparing the Library for Operation

To prepare the library for operation:

•

Close the library door and access panels

•

Connect the host workstations

Closing the

Library Doors and

Access Panels

The library has one front door and one back access panel.

Close and lock the front door.

Turn the door latch to secure the door to the library frame.

Lower the latch over the door lock.

Using the key from the accessory kit, lock the latch in place.

Using the key from the accessory kit, lock the latches in

place.

Close and lock the back access panel using a 5/32 hex wrench

(not provided).

Connecting Host

Workstations

Connect the SCSI cables and jumpers as shown in the applicable

figures.

Figure 13

and figure 14 on the following pages show the

recommended cabling configurations for the 10-drive and 8-drive

library, respectively.

Note:

ATL ships sufficient SCSI cables and terminators with

this library to set up two-drives per SCSI bus, as well as

adequate SCSI jumper cables to accommodate up to 4

drives per SCSI bus.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 145 146

Keine Kommentare

Quantum P2000 Betriebsanweisung Seite 42