Quantum Scalar 24 Betriebsanweisung PDF herunterladen (Seite 58)

50 Using the Remote Management Unit

Setting up the RMU

Once you have established a network address for the RMU, input this information to the RMU by using the

operator panel.

1 From the Setup menu, highlight and press .

2 Set the IP address, subnet mask, and gateway address by pressing and to change the value of

the current field and and to move to the next field.

3 When complete, highlight Execute ( ) and press .

Starting the RMU

Before you begin using the RMU, make certain you have configured your RMU with the correct network

address.

1 Open a Web browser.

2 Point your browser to the RMU IP address, excluding any leading zeros.

For example if your IP address is 182.073.056.502 on the operator panel LCD, go to the following

address: http://182.73.56.502

The RMU user interface is now displayed.

Using the RMU

The following sections describe how to set up features of the RMU, use the RMU to control the library, and

use the RMU to monitor library status.

Logging into the RMU

Some of the features of the RMU require you to log in.

• When prompted, enter your login name and password.

Checking Status and General Information

You can use the RMU to remotely check the status of a library and obtain general information about the

library. For example, you can check drive status or get the firmware level of your library. The library

automatically backs up vital product data every time you move from an offline to an online state in order to

preserve configuration information.

• Click the Status tab.

The following information is displayed:

Note

For information on determining or setting your RMU IP address, refer to

Configure Net Device

on page 86.

Note

The default login and password are admin and secure, respectively.

Note

The login name and password are case sensitive.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 159 160

Keine Kommentare

Quantum Scalar 24 Betriebsanweisung Seite 58