Quantum TC-L32BX-EY Betriebsanweisung PDF herunterladen (Seite 29)

Chapter 2 Installation Procedures

Installing the Internal LTO-3 Half-Height Tape Drive

LTO-3 Half-Height Tape Drive User’s Guide 15

Figure 5 Internal Tape Drive

Mounting Holes

Connecting the Internal

Drive Interface and DC

Power Cables 2

As shown in figure 6 and figure 7, the rear panels of the internal LTO-3

Half-Height Tape Drives have connectors for:

• Either a 68-pin parallel SCSI or a 7-pin 1x SATA style interface cable

• A serial library interface cable

• The internal drive DC power cable

Connect the interface and DC power cables to the internal drive as

follows:

1 Verify that the system is shut down and the AC power cord is

disconnected from the facility AC power receptacle.

2 Depending on the interface configuration of your internal drive:

a For the parallel SCSI internal drive:

• Attach the internal parallel SCSI interface cable to the 68-pin

parallel SCSI connector on the back of the drive.

Caution: The LTO-3 Half-Height Tape Drive with the

parallel SCSI interface is a low voltage

differential (LVD) SCSI device. Install it only

in LVD environments. Plugging an LVD drive

into a high voltage differential (HVD) bus

makes the entire bus nonfunctional and may

permanently damage the drive or other SCSI

devices on the bus.

Lower mounting holes

Upper mounting holes

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 108 109

Keine Kommentare

Quantum TC-L32BX-EY Betriebsanweisung Seite 29