Quantum Scalar 100 Betriebsanweisung PDF herunterladen (Seite 37)

SNC 6101 User’s Guide 33

Maintenance

This section provides procedures for the removal, replacement, and testing of the SNC 6101.

Updating Firmware and Configurations

Although the ADIC Management Console (AMC) is the simplest and most efficient tool for updating firmware

and saving/loading configurations, the administrator can use the service terminal as an alternate method to

perform these operations. For more information on using the AMC to update firmware and configuration,

refer to the ADIC Management Console User’s Guide. For more information on updating firmware and

configuration through the service terminal, refer to To configure the SNC 6101

on page 22.

Connecting to the SNC 6101 using the Service Port

The service port is an RS-232C Data Terminal Equipment (DTE) port. Its 9-pin connector is compatible with

serial ports on a PC using a 9-pin to 9-pin null modem cable.

Once the service terminal has been attached to the SNC 6101 service port, a terminal emulation program

will be required to access the command line interface.

Most operating systems come with HyperTerminal or some other form of terminal emulation program by

default. If a terminal emulation program is not present, one should be available (or at least recommended)

by your operating system provider.

For instructions on cabling a PC to the SNC 6101 and setting up HyperTerminal, refer to To cable the

service port to your laptop/desktop computer on page 21.

Note

For service port access using other equipment, such as a UNIX workstation, a

different cable or an adapter may be required.

Note

Configuration commands that are available to control, manage, and service the

SNC 6101 are documented in SNC Firmware 4 User’s Guide. Refer to the

“Service Port Command Reference” section.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Keine Kommentare

Quantum Scalar 100 Betriebsanweisung Seite 37