Quantum L200 Betriebsanweisung PDF herunterladen (Seite 33)

Chapter 2 Installing the Library

Connecting the Library

Quantum|ATL PowerStor L200 Series Library User’s Guide 17

Connect the other end of the short SCSI cable to the tape drive

SCSI connector closest to library controller.

4 If the is a stand-alone external SCSI device, install the SCSI

terminator in the connector at the far left (looking at the back of

the library). Verify that the SCSI bus is terminated properly.

Figure 10 SCSI

Cabling stand-alone

Connection Scenario

Connect one end of the long SCSI cable supplied with the

library to the SCSI connector closest to the power switch on the

back of the library. Connect the other end of this cable to the

host’s SCSI adapter connector.

6 Secure the cables, using the wire cable clamps or screws

provided.

7 Connect the power cord to the power connector on the back of

the library (see figure 9

8 Connect the other end of the power cord to the site power.

Note: Depending on the system configuration, the SCSI bus

initiates at the host, connects to the library controller,

then to the tape drive, and then to any other SCSI

devices on the bus. It must be terminated at the last

SCSI device on the bus (see figure 10

Host

SCSI cable to next SCSI

Library Controller

Drive (SCSI ID 1)

Supplied SCSI cables

Library (Top)

(SCSI ID 0)

device (or install the

supplied teminator)

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 111 112

Keine Kommentare

Quantum L200 Betriebsanweisung Seite 33