Quantum L200 Betriebsanweisung PDF herunterladen (Seite 63)

Chapter 4 Using the Library

Using Tape Cartridges

Quantum|ATL PowerStor L200 Series Library User’s Guide 47

To use a cleaning cartridge on a non-SDLT type tape drive:

1 Open the library door (see Opening the Library Door on

page 41).

2 Remove the 6-cartridge magazine.

3 Insert the cleaning cartridge into slot 7 (see figure 11).

4 Replace the 6-cartridge magazine.

5 Close the library door (see Closing the Library Door).

6 Load the cleaning cartridge into the drive:

a Press Select until the message LOAD? is displayed.

b Press Enter to display the message From Slot #?.

c Select 7 and press Enter to display the message To Drive.

d Press Enter to automatically begin the cleaning routine.

7 When the cleaning routine is complete, unload the cleaning

cartridge into its original slot (see Unloading a Cartridge

The cleaning cartridge can be used 20 times. When the drive

detects that a cleaning cartridge has expired, the drive rewinds and

unloads the cartridge. If the cleaning routine is run on a cleaning

cartridge that has not expired, Cln is cleared from the OCP after

the tape rewinds and unloads. The Cln message is cleared when

the tape drive successfully completes a cartridge calibration

routine after a retry.

Handling and

Storing Cleaning

Cartridges

To limit use of a cleaning cartridge:

• Avoid touching leaders and media with bare fingers. Oils and

grease from the skin are especially damaging and may cause

drive failures that require drive replacement.

• Maintain a clean work area to ensure drive reliability.

• Select a site away from line printers, cardboard boxes, or other

sources of dust and debris.

• Follow handling and storage guidelines.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 111 112

Keine Kommentare

Quantum L200 Betriebsanweisung Seite 63