Quantum PX502 Betriebsanweisung PDF herunterladen (Seite 61)

Chapter 1 Library Description

Getting Started

Quantum PX500 Series User’s Guide 38

Cabling the Quantum

PX500 Series 1

After the Quantum PX500 Series is in its final location, the tape drives

and system controller board must be connected to the backup host

system(s).

To cable the Quantum PX500 Series:

1 The PX500 Series tape drives and system controller board are

accessed from the back of the library (refer to

“Connecting to Host

Workstations” on page 51).

2 Connect Ethernet port located on the back of the library on the

system controller board to the local area network (see

figure 18).

Figure 18 Connecting the

Library to the Local Area

Network

Loading Tape Cartridges 1

Before operating the library, load the appropriate tape cartridges (LTO or

SDLT) into the library starting with the left-hand panels (see

“Library

Models” on page 2 for slot locations).

Warning: If the rack is empty at the time of installation, do NOT

install the PX-Series modules too high in the rack. The

combined weight of the components may cause the rack

to become “top heavy” and unstable if installed in the top

of an empty rack. If installing a multiple library stack,

begin installing the bottom library module first.

Ethernet port

System controller board

PX502 shown

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 293 294

Keine Kommentare

Quantum PX502 Betriebsanweisung Seite 61