Quantum TC-L53FN-AR Betriebsanweisung PDF herunterladen (Seite 24)

Chapter 2 Installation Procedures

Installing the Internal LTO-5 Tape Drive

10 LTO-5 Tape Drive User’s Guide

4 Position the drive in the bay and align either the upper or lower

mounting holes—whichever is appropriate—with the holes in the

chassis (see figure 4

5 Secure the drive using two Phillips screws labeled General

Mounting Screws on each side of the tape drive. If you cannot

tighten the Phillips screws, use the washers provided with the

General Mounting Screws.

Caution: Using screws other than the Phillips screws labeled as

General Mounting Screws can damage the tape drive.

Do not use screws other than the General Mounting

Screws to secure the internal LTO-5 Half-Height Tape Drive.

After mounting the internal LTO-5 Half-Height Tape Drive, proceed to

Connecting the Internal Half-Height Drive Interfaces

in the following

subsection.

Figure 4 Internal Tape Drive

Mounting Hole Locations

Lower mounting holes

Upper mounting holes

Washer

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 95 96

Keine Kommentare

Quantum TC-L53FN-AR Betriebsanweisung Seite 24