Quantum TC-L53FN-AR Betriebsanweisung PDF herunterladen (Seite 25)

Chapter 2 Installation Procedures

Installing the Internal LTO-5 Tape Drive

LTO-5 Tape Drive User’s Guide 11

Connecting the Internal Half-Height Drive Interfaces

As shown in figure 5, the rear panel of the internal LTO-5 Half-Height

Tape Drive has connectors for:

• 29-pin SAS SFF-8482 cable

Figure 5 Internal Drive

Interfaces

Connect the interface cables to the internal drive as follows:

1 Verify that the system is shut down and the AC power cord is

disconnected from the facility AC power receptacle.

2 Connect the SAS connector on the back of the tape drive to a serial

SCSI host bus adapter (HBA) installed in the server.

3 Ensure that a 4-pin Molex power connector is plugged into the

power inputs of the SAS cable as shown in figure 5

4 Reinstall the system cover.

5 Reconnect the system AC power cord to the facility AC power

receptacle.

After connecting the internal drive interfaces, proceed to Restarting the

Internal Half-Height Tape Drive System in the following subsection.

29 position SAS SFF-8482 connector

4-pin Molex power connector

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 95 96

Keine Kommentare

Quantum TC-L53FN-AR Betriebsanweisung Seite 25