Chapter 2 Basic Library Operations
Turning the Library On and Off
Quantum|ATL P3000 Series User’s Guide 23
Turning the Library On and Off
2
This section explains how to:
•Turn on the library
• Place the library on-line or off-line
• Turn off the library
• Test the installation
Turning On the
Library
2
To turn on the library:
1
Verify that:
• Power cables are firmly in place
• All doors are closed
2
Turn on the power switch located behind the small sliding
door below the GUI.
3
After several seconds, verify that the current state of the library
(“System On-line” or “System Off-line”) appears in the System
State display on the GUI (see figure 12
).
Placing the Library
On-line or Off-line
2
With the library turned on, press the Standby button on the GUI.
Pressing the Standby button toggles the library between on-line
and off-line states.
Turning Off the
Library
2
To turn off the library:
1
Place the library off-line by pressing the Standby button.
The library robotics completes any current commands and then
stops.
2
Verify that the GUI display indicates “System Off-line.”
Kommentare zu diesen Handbüchern