Quantum Scalar i500 Betriebsanweisung PDF herunterladen (Seite 193)

100

101

Chapter 7 Encryption Key Management

Configuring Encryption Key Management on the Library

Scalar i500 User’s Guide 174

• SKM — The port number is always 6000. You cannot change

SKM port numbers.

• KMIP Key Manager — The port number must match the

configured port number on the KMIP key manager server. A

typical port number used for communication between the KMIP

key manager server and the library is port 9003.

9 Click

Apply.

10 Ensure all ports corresponding to the EKM servers are open on your

firewall to allow the library to connect to the servers. For SKM, ports

80, 6000, and 6001 must be open.

Step 4: Installing TLS Certificates on the Library (SKM Only)

If you are running SKM or a KMIP key manager, Transport Layer

Security (TLS) communication certificates with valid dates must be

installed on the library in order for the library to communicate securely

with attached EKM servers.

Note: If you are using a secondary Q-EKM key server, then

the port numbers for both the primary and secondary

key servers must be set to the same value. If they are

not, synchronization and failover will not occur.

Note: You cannot edit the encryption system configuration

settings when any partition is enabled for library

managed encryption. If this happens, go to Setup >

Encryption > Partition Configuration, change all EKM

partition settings from Enable Library Managed to

Allow Application Managed. Then make your changes

to the system configuration settings. Finally, go back and

change all the EKM partition settings to Enable Library

Managed.

Note: If you are using Q-EKM, skip this step. No TLS certificates are

required.

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 569 570

Kommentare zu diesen Handbüchern

Keine Kommentare

Quantum Scalar i500 Betriebsanweisung Seite 193

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Quantum Scalar i500