Quantum Scalar 218 Spezifikationen PDF herunterladen (Seite 93)

Scalar 218 Rack-Mount Installation 83

Installing the Cable Channel

The next step in the installation process is to install the cable channel bracket, cable channel,

and channel stop at the rear of the rack. The cable channel will keep the SCSI cable(s) orderly

and prevent them from hampering the movement of the Scalar 218 whenever it is slid forward

on the rails. The cable channel is secured to a channel bracket with a quick-release pin.

p At the rear of your rack, select the pair of holes in the rack upright where you wish to

install the cable channel. adic recommends that you use a pair of holes that vertically is

at about the same height as the AC power connector on the rear panel of the Scalar 218.

p Install the cable channel bracket using two 10-32 x ½” Phillips head screws and two

collared spacers.

p Install the channel stop using two 10-32 x ½” Phillips head screws and two collared

spacers.

p Secure the power cord and SCSI cable to the cable channel using the attached cable ties.

Be sure to leave enough slack in the cables to allow the Scalar 218 to be pulled away from

the rack as far as the slide stops permit. The illustration on the following page shows how

the channel should be installed in your rack.

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 108 109

Keine Kommentare

Quantum Scalar 218 Spezifikationen Seite 93