Quantum L200 Betriebsanweisung PDF herunterladen (Seite 32)

Chapter 2 Installing the Library

Connecting the Library

16 Quantum|ATL PowerStor L200 Series Library User’s Guide

Connecting the Library 2

Complete the following procedure to connect the power cord and

SCSI cables to the library (see figure 9

Figure 9 Rear Panel

Cable Connectors

To connect the library:

1 Verify that the library’s power switch is in the off position. It is

not necessary to power down the host.

2 Connect one end of the short SCSI cable supplied with the to

the library controller’s SCSI connector closest to the tape drive

(see figure 10

Caution: Verify that the library controller is connected to the

same type of SCSI bus as the drive on that bus. For

example, connecting a single-ended SCSI library to a

differential SCSI adapter will cause a host system

malfunction.

Power switch

Power connector

Power supply

SCSI connectors

(library controller)

Serial port

(FSE use only)

Tape drive assembly

Connect to a

SCSI device

(or install

terminator)

Connect

together

Connect to

host

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 111 112

Keine Kommentare

Quantum L200 Betriebsanweisung Seite 32