Quantum L200 Betriebsanweisung PDF herunterladen (Seite 50)

Chapter 3 Operator Control Panel

Mode

34 Quantum|ATL PowerStor L200 Series Library User’s Guide

• Sequential NOT Selected

• Sequential Circ NOT Selected

• Autoload Cart: N

• Enable Barcode: N

• AutoClean: N

4 Press Enter to toggle the mode options.

Enter executes the Selected mode and toggles all other modes

to NOT Selected.

For example, if you toggle the Sequential mode to Selected, the

Random and Sequential Circ modes are automatically toggled

to NOT Selected

. Enter also toggles each of the Y and N

options.

5 Press Select to return to the main menu.

Optional

Autoclean Mode

If the optional autoclean is enabled, the time that a SCSI Move

Media command takes to complete increases from approximately

20 seconds to 60 seconds because the library must wait until

calibration is complete. If cleaning is required, the typical time

increases to a maximum of 10 minutes while the drive is cleaned.

To use:

1 Load the cleaning cartridge into slot 7.

2 Press Enter to enable AutoClean: Y.

When AutoClean is enabled, the status of slot 7 becomes

unviewable. The OCP cannot be used to load a cleaning cartridge.

After the manual cleaning cycle is complete, the second line of the

OCP will display an idle message. Turn off the library. Wait at

least ten seconds. Turn on the library. After the initialization

process is complete, set the AutoClean parameter to N. The

cleaning cartridge may then be ejected.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 111 112

Keine Kommentare

Quantum L200 Betriebsanweisung Seite 50