Quantum 1200 Series DAT Autochanger Bedienungsanleitung PDF herunterladen (Seite 75)

Chapter 3 Installing Your Tape Drive

Configuring and Installing an Internal Tape Drive with Fibre Channel Interface

SDLT 600 Product Manual 59

Optional Loader

Connector

The 8-pin optional loader connector provides signals to be used when the

tape drive is part of a loader/library configuration. Figure 11

shows the

location of this connector; table 30

on page 55 lists pin assignments for the

loader connector.

Connect the Fibre Channel

Cable

1 Fibre Channel cables are hot-swappable—meaning you may connect

and disconnect them with unit power on. Therefore, unlike other

systems, the tape drive and computer may remain on to connect the

SDLT 600 tape drive to the host computer.

2 Insert the fiber optic cable into the Fibre Channel port on the back of

the tape drive as shown in figure 12

. The connector is fully seated

when it snaps into the port.

Figure 12 Connecting the Fiber

Optic Cable

Note: When connecting to the Fibre Channel port, make sure to use a

50μM Fiber core fiber optic cable with an LC, Duplex

connector.

Fiber optic cable

SDLT 600

tape drive

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 141 142

Keine Kommentare

Quantum 1200 Series DAT Autochanger Bedienungsanleitung Seite 75