Quantum 1200 Series DAT Autochanger Bedienungsanleitung PDF herunterladen (Seite 88)

Chapter 4 Using Your Tape Drive

Updating the Firmware

SDLT 600 Product Manual

• If you experience errors, doublecheck the tape drive’s configuration

and setup, using the ideas provided in Troubleshooting

on page 80.

• After you have exhausted all troubleshooting alternatives, contact

your service representative.

•Press the

Eject button to unload the data cartridge. If you are unsure

which button is the

Eject button, see figure 20 on page 77.

Updating the Firmware 4

When you need to update the firmware in a tape drive, you can do it

either of two ways:

• By directly using the SCSI bus

• By creating a firmware image data cartridge (CUP/FUP) to use in

either a manual firmware update or in a library setting.

DLTSage provides the tool that allows you to update the tape drive’s

firmware using the SCSI bus, or to create a CUP/FUP data cartridge for

an SDLT 600 tape drive. DLTSage is available on the Quantum Web site,

http://www.quantum.com

. Quantum Diagnostics Tools on page 10 in

provides details on locating DLTSage in the Quantum Web site.

The following subsections briefly describe both methods of updating the

tape drive firmware.

Update the Firmware

Using the SCSI Bus

Quantum provides upgrades for product software and firmware that

may be newly developed. These updates are available on the Quantum

Web site.

Note: You can review specific instructions for loading a data

cartridge in the appendix

A, Super DLTtape I and Super

DLTtape II Data Cartridges and appendix B, DLTtape VS1

Data Cartridge.

Note: These tools are only available to registered Quantum

customers.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 141 142

Keine Kommentare

Quantum 1200 Series DAT Autochanger Bedienungsanleitung Seite 88