Quantum DLT 4000 Handbuch PDF herunterladen (Seite 50)

Hardware Implementation

2-16 Quantum DLT 4000 Tape Drive

Figure 2–9 Tabletop (Version 2) Back Panel Connectors

Align the appropriate SCSI and power cables to their matching connectors.

Carefully connect the cables and avoid bending or damaging the connector pins.

1. Make sure the power switch is in the off (0) position.

2. Connect one end of the SCSI cable to the SCSI IN connector on the back

panel of the drive. Connect the other end of the SCSI cable to the SCSI

connector on your system, or for daisy-chained configurations, to another

SCSI device.

3. Snap the wire cable clamps into place to secure the cables.

4. Be sure to terminate the SCSI bus. If the tabletop drive is the last or only

device on the bus, terminate the bus by connecting the SCSI terminator to

the SCSI OUT connector on the back of the drive. Depending on the

terminator supplied, snap the wire cable clamps into place or tighten the

screws to secure the terminator.

If the tabletop drive is not the last or only device on the bus, install a

terminator on the last device on the SCSI bus.

5. Connect one end of the power cord to the power connector on the back of the

drive. Connect the other end of the cord to the ac outlet.

Power Switch

Power Connector

SCSI Signal Connector

(Out/Termination)

SCSI ID Pushbutton

SCSI Signal

Connector (IN)

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 299 300

Keine Kommentare

Quantum DLT 4000 Handbuch Seite 50