Quantum L500 Betriebsanweisung Seite 39

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 120
  • Inhaltsverzeichnis
  • FEHLERBEHEBUNG
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 38
Chapter 2 Installing the L500 Series Library
Connecting the Tape Library
Quantum|ATL PowerStor L500 Series Tape Library Users Guide 23
To connect the tape library:
1
Verify that the power switch is in the off position.
2
Connect one end of the SCSI cable to the SCSI cable connector
on the library card, which is accessible from the back of the
tape library.
3
Verify that the SCSI bus is terminated properly.
Depending on the system configuration, the SCSI bus initiates
at the host, connects to the library controller, and then to any
other SCSI devices on the bus. It terminates at the last SCSI
device on the bus. SCSI cabling connections are shown in
figure 18
.
Figure 18 Sample
SCSI Cable
Connection
4
Install the SCSI cables and tighten the screws to secure all
cables.
5
Connect the power cord to the power connector on the back of
the tape library (figure 17
).
6
Connect the other end of the power cord to the AC power
source.
Host
Library
Library card (SCSI ID 0)
Drive 2 (SCSI ID 3)
Drive 0 (SCSI ID 1)
Drive 1 (SCSI ID 2)
SCSI cables
Next SCSI device or terminator
Seitenansicht 38
1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 119 120

Kommentare zu diesen Handbüchern

Keine Kommentare