Quantum DLT 2500 Wartungshandbuch PDF herunterladen (Seite 29)

Inserting the Sled-Mounted DLT2000XT Tape Drive

Figure 2-4 shows jumpering for SCSI IDs.

Figure 2-4 Setting the SCSI ID on the Sled-Mounted Tape Drive

Inserting the Sled-Mounted DLT2000XT Tape Drive

After you have completed conﬁguration procedures for each sled-mounted DLT2000XT

tape drive, you are ready to install it in a deskside SCSI rack, rackmounted “stubby”

SCSIBox 2, or Vault Rack SCSIBox 2.

Caution: Use proper handling and storage procedures to minimize the loss of data and

equipment. Be sure to use standard electrostatic discharge prevention precautions when

removing, storing, transporting, or replacing a DLT2000XT tape drive.

The following sections provide speciﬁc information on how to install the sled-mounted

DLT2000XT tape drive in available Challenge or Onyx SCSI housings. The instructions

presume that you have some experience working with these systems. If not, review the

chapter on installing SCSI devices in the owner’s guide for that system.

Note: You need a #2 Phillips-head screwdriver to install the DLT2000XT tape drive.

Installation requires removing a drive shelf from the SCSI rack or box where the

DLT2000XT tape drive will be installed.

SCSI ID 0

SCSI ID 1

SCSI ID 2

SCSI ID 3

SCSI ID 4

SCSI ID 5

SCSI ID 6

SCSI ID 7

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 113 114

Keine Kommentare

Quantum DLT 2500 Wartungshandbuch Seite 29