Quantum DLT 2500 Wartungshandbuch PDF herunterladen (Seite 67)

Configuring the Host System to Recognize the DLT2500XT Stacker

To set the SCSI ID, follow these steps:

1. Press and hold the Display Mode button on the front of the stacker for about ﬁve

seconds until the SCSI ID SEL message displays, showing the factory-set SCSI ID.

For example:

SCSI ID SEL

SCSI ID 5

2. Press the Select button until the ID number you want displays.

3. Press the Display Mode button; the message LDR RDY displays.

4. To make the stacker recognize the SCSI ID, issue a bus reset or power-cycle the

stacker (turn the power off, and then on again).

Conﬁguring the Host System to Recognize the DLT2500XT Stacker

Depending on whether you installed one or two DLT2500XT stackers, some

conﬁguration steps may be necessary. The hinv command can conﬁrm if your system

recognizes the new DLT2500XT stacker installed. Chapter 6 provides sample hinv

listings.

If you installed only a DLT2500XT stacker, it should be ready to use with your system. If

hinv does not see an externally mounted DLT2500XT stacker, please read “What to Do If

hinv Does Not See the Tape Drive” in Chapter 6.

For automated backup software operating instructions, please see the IRIX Networker

Administrator’s Guide and the NetWorker for IRIX User’s Guide.

For general information on backing up and restoring data using a tape drive, see the

Personal System Administration Guide. Additional information is also available in IRIX

Admin: Peripheral Devices.

Installing the SCSI Patch

Once you have installed the DLT2000XT tape drive in the chassis, load the CD supplied

with the tape drive. Follow information in the release notes for which patches to install

for your system; install the patch(es) with the Inst utility.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 113 114

Keine Kommentare

Quantum DLT 2500 Wartungshandbuch Seite 67