Quantum DLT 2500 Wartungshandbuch PDF herunterladen (Seite 51)

Connecting the Desktop DLT2000XT Tape Drive to the Host

4. Snap the wire cable clamps into place to secure the cable.

5. If you are connecting one more desktop DLT2000XT tape drive to an Indy or Indigo

workstation, use only a half-meter Centronics 50-pin to Centronics 50-pin X5-SCSIA

cable. Attach one end to the top connector on the ﬁrst tape drive and the other end

to the bottom connector on the last tape drive.

If you are connecting one more desktop DLT2000XT tape drive to a Challenge or

Onyx system, use only a one-meter Centronics 50-pin to high-density 50-pin (part

number 018-8124-001, with marketing code P-S-DLT25XT-SA).

6. If the DLT2000XT tape drive is the last or only device on the SCSI bus, you must

terminate the bus by installing the terminator included in the shipment to the top

SCSI connector, as shown in Figure 3-3.

Figure 3-3 Terminating the DLT2000XT Desktop Tape Drive

Terminator

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 113 114

Keine Kommentare

Quantum DLT 2500 Wartungshandbuch Seite 51