Quantum DLT VS160 Bedienungsanleitung PDF herunterladen (Seite 72)

Diagnostics and Troubleshooting

Removing Stuck Cartridges

58 Quantum ATL ValueLoader DLT VS80/DLT VS160 Tape Autoloader User Manual

Removing Stuck Cartridges 4

If the ValueLoader experiences a severe mechanical problem or if

you need to remove cartridges because of the power failure or

other circumstance in which the ValueLoader is unable to export

the cartridges in the carousel, follow these steps:

1 Move the power switch on the front panel to the OFF position.

You may need to use the tip of a pen or similar item to move

the power switch.

“!” in ValueLoader

operator panel inventory

display

• An exclamation point (!) displayed in the inventory indicates

that the ValueLoader has identified a cartridge in the indicated

slot that is either an invalid cartridge type (DLTtapeIII

cartridge or non-DLT1 cleaning cartridge) or has had media-

related error. These can be caused by faulty or improperly

degaussed media, media that has been previously written in

an invalid format such as DLT7000 or DLT8000, or dirty read/

write heads in the tape drive. The Media Attention LED is also

illuminated in this case. See LED Indicators

on page 25 for

more information. Exporting the indicated cartridge will clear

the error condition. See Exporting Cartridges

on page 29. If

these symptoms occur on multiple known good cartridges,

consider cleaning the tape drive. See Cleaning the Tape Drive

on page 34. If a particular cartridges causes these symptoms

repeatedly, that cartridge may be defective or invalid.

There is an error code on

the LCD display

• Look up the error code, and try to resolve the failure, and

power cycle.

Note:

Contact Quantum Customer Support if a cartridge is

stuck in the drive.

Problem Solution

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 89 90

Keine Kommentare

Quantum DLT VS160 Bedienungsanleitung Seite 72