Quantum 1200 Series DAT Autochanger Betriebsanweisung PDF herunterladen (Seite 107)

SDLT 600 SCSI Interface Guide Chapter 4: SCSI Commands

81-81200-02 REV A01 January 2005 4-65

Table 4-40. Log Parameters for Device Status LOG SENSE Page — Field Descriptions

Field Name Description

Parameter Code Parameter codes 0000h through 000Ah are supported:

Code Description

0000h Specifies the device type. For sequential-type devices

such as tape drives, the value is always 00010000h.

0001h Specifies device cleaning-related status (see

Figure 4-36).

0002h Specifies the number of loads over the lifetime of the

drive.

0003h Specifies the number of cleaning sessions per cartridge.

0004h Vendor specific.

0005h Drive temperature in degrees C.

0006h Media ID of the most recently loaded cartridge.

0007h Controller serial number (least significant 16 bits). The

drive uses this value to generate the Media ID for blank

tape cartridges.

0008h Drive cleaning cycle count.

0009h Serial number of the first drive to write the current tape.

000Ah Serial number of the last drive to write the current tape.

DU Disable Update. Always set to 0.

DS Disable Save. Not supported. Always set to 1.

TSD Target Save Disable. Not supported. Always set to 1.

ETC Enable Threshold Comparison. Not supported. Always set to 0.

TMC Threshold Met Criteria. Always set to 0.

LBIN List Binary. Not used.

LP List Parameter. The drive treats the parameter codes as data counters.

Always set to 0.

Parameter Length Specifies the number of bytes in the parameter value. All parameters are

4 bytes in length.

Parameter Value Indicates the actual value of this log parameter.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 293 294

Keine Kommentare

Quantum 1200 Series DAT Autochanger Betriebsanweisung Seite 107