Quantum P2000 Betriebsanweisung PDF herunterladen (Seite 58)

Chapter 2 Basic Library Operations

Operating the Load Port

38 ATL P2000 Series Automated Tape Library User’s Guide

Operating the Load Port

After pressing the Load Port button on the touch screen GUI, the

library will release the lock on the load port (you will hear an

audible ‘click’). The touch screen GUI displays “Wait Open Load

Port.” Pull on the load port’s finger grip. The load port pulls

outward about an inch to its unlocked position which allows its

interior drum to be rotated 180

for magazine loading or

unloading.

After loading or unloading the magazines, rotate the load port

drum back 180

and push the load port into its locked position.

Removing/

Installing a Tape

Cartridge

Magazine

To remove a DLT/SDLT magazine from the load port, press up on

the metal tab at the upper right corner of the load port bay. Rotate

the magazine handle from the top of the magazine toward you and

pull the magazine from the loadport. Reverse this procedure to

install a magazine (see figure 8

on page 16).

Warning:

Opening or closing the load port door presents

mechanical hazards. Use both hands to pull or push

the load port finger grip and use the top and bottom

surfaces of the load port drum to keep fingers out of

load port openings when rotating the load port drum

(see figure 22

Note:

The mixed media load port used with LTO tape cartidges

has two stationary 4-cartridge static magazines built into

the load port, unlike the two removable 6-cartridge

magazines used with DLT and SDLT tape cartridges. If

the library contains both DLT and LTO tape drives, the

stationary magazines are used in the load port.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 145 146

Keine Kommentare

Quantum P2000 Betriebsanweisung Seite 58