Quantum LTO 4 Betriebsanweisung PDF herunterladen (Seite 33)

Chapter 2 Installation Procedures

Installing the Tabletop LTO-4 (Model B) Half-Height Tape Drive

LTO-4 (Model B) Half-Height Tape Drive User’s Guide 17

5 Registering the LTO-4 (Model B) Half-Height Tape Drive on page 23.

Configuring the

Tabletop Parallel SCSI

Ta p e Drive

The factory-set default configuration of the tabletop parallel SCSI LTO-4

(Model B) Half-Height Tape Drive is:

• SCSI ID: 6

• Terminator power: enabled

IF the default parallel SCSI ID configuration is . . .

THEN you can . . .

compatible with your system

SCSI bus,

skip the following subsection and proceed to Connecting the Tabletop

Drive Interface and AC Power Cables on page 18.

already assigned to another device,

change the configuration of either the other device, or the LTO-4 (Model

B) Half-Height Tape Drive, as described in the following subsection.

Note: You cannot disable terminator power on a tabletop parallel

SCSI drive.

Configuring the Tabletop Drive Parallel SCSI ID

Each device on the parallel SCSI bus must have its own unique SCSI ID.

Use the push-button SCSI ID selector switch on the drive back panel to

change the SCSI ID of the tabletop LTO-4 (Model B) Half-Height Tape

Drive (see figure 8

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 97 98

Keine Kommentare

Quantum LTO 4 Betriebsanweisung Seite 33